Instructions on how to suck a newborns nose using a syringe

Nasal aspiration for babies is a method of clearing the airways when a baby has a stuffy nose, helping the baby breathe more easily and feel more comfortable.

Infants often have a runny or stuffy nose . This is caused by a buildup of mucus inside the nose and respiratory tract. In addition to using a cotton swab, parents will have to suck the infant's nose using a syringe or U-shaped suction device if needed.

Nasal aspiration for babies using a syringe

1. Put salt water in your nose

To help loosen mucus, use a small salt water solution into your child's nasal passages. Lie down and tilt your baby's head a little. Place 1 - 2 drops of the solution into the nose. Try to let the liquid stay in the baby's nose for about 10 seconds.

2. Wait a few minutes

After putting the saline solution into the baby's nose, wait 2 - 3 minutes. Keep the baby's head lower than the legs. This helps the solution go deep into the nose. The stuffy nose will subside and your baby can breathe more easily. However, if your baby is still wheezing after a few minutes, then you should repeat the saline drip.

3. Place the syringe in front of the baby's nose

Squeeze the plunger to expel all of the air, then place the tip of the tube in front of the baby's nose so that the nose is blocked. Gently release the handle to absorb the mucus.

If your baby has any objections, do not impatiently force the child to suck the mucus immediately, but try again later.

Do not let the tip of the pump go too deep into the nose to avoid harm.

4. Clean the syringe after suctioning one side of the nose

Before proceeding with the nasal suction of the infant on the other side, you need to first remove the mucus from the tube. Squeeze to remove any dirt, then use water or a paper towel to clean the end of the tube.

5. Repeat

Darling should be able to breathe better after clearing the mucus from her nose. However, if your baby's nose is still stuffy after 5 - 10 minutes, repeat the whole process again.

Nasal aspiration for babies using a U-shaped tool

1. Place the nozzle in front of the baby's nose

Place the large tip of the nozzle in the baby's nose. The tapered end is connected to a long cylindrical tube, where mucus is obtained from the nose.

2. Smoking mucus

Place it over your mouth and suck the other end of the tool. The amount of mucus removed from your baby's nose depends on how much force you attract. You will not be absorbing the mucus as the tool has been specially designed to prevent this.

3. Sanitation

After the infant is finished, disassemble each part of the tool and wash it thoroughly with soap and clean water.