
引っかき傷を防ぐために、グルーブジョイントプライヤーのジョーまたはエアレーターの周りにマスキングテープを巻き付けます。
エアレーターの表面を保護します。

ペンチでエアレーターの外側をつかみ、エアレーターを時計回りに回して緩めます。
穏やかな; 圧力が高すぎると、エアレーターハウジングが押しつぶされる可能性があります。

エアレーターを分解します。
内部部品をエアレーターハウジングから押し出します。小さなペーパークリップが役立つ場合があります。コンポーネントが詰まっている場合は、エアレーターを白酢または石灰溶解液(酢1部と水1部)に30分間浸します。
Tip: Cover the sink drain to prevent small parts from accidentally falling down the drain.
Disassemble the aerator.
Push the internal parts out of the aerator housing. A small paper clip might help. If the components are stuck, soak the aerator in white vinegar or lime-dissolver solution (one part vinegar to one part water) for 30 minutes.
Tip: Cover the sink drain to prevent small parts from accidentally falling down the drain.

Use an old toothbrush and a gentle touch to clean the parts.
Don’t bend the screens or you’ll have to replace them.

Reassemble the aerator parts.
Insert the screen, disk, and washer or O-ring (depending on your aerator’s design) in reverse order of disassembly.

Reinstall the aerator on the faucet.
Screw it in by hand in a counterclockwise direction. Use the pliers to tighten securely but there’s no need to over tighten it. Snug is good!