
フレームを取り外し、作業台に平らに置きます。
ドアからフレーム内のスクリーンを取り外し、ワークベンチまたはのこぎりのセットの上に平らに置きます。

フレームの背面にある溝からスプラインをこじ開けます。
小さなペンチまたは大工の千枚通しを使用して、スプラインを溝からこじ開けます。角がきつい場合は、ドライバーを使用してスプラインを取り外します。スプラインの形状が良好であると思われる場合は、新しい画面で使用できるように取っておきます。
スプラインがもろい、またはひびが入っている場合は、新しいスプライン(金物店で入手可能)と交換する必要があります。

損傷した画面を持ち上げます。
Holey screens let in insects — and bats, if the hole is big enough.
Lift out the damaged screen.
Holey screens let in insects — and bats, if the hole is big enough.

Wipe the spline groove clean.
Be sure that you remove even the tiniest grit. You can use the tip of a screwdriver or awl to get into the groove if necessary.

Lay the new aluminum screen over the frame.
Be sure that it overlaps the groove by at least 1/8 inch on all four sides.

Cut the screen at a 45-degree angle at the corners.
Cut off the corners of the screen at a 45-degree angle, just inside the outer edge of the spline groove.
Cut the screen at a 45-degree angle at the corners.
Cut off the corners of the screen at a 45-degree angle, just inside the outer edge of the spline groove.

Press the screen into the groove using the convex end of the splining roller.
Hold the roller at a 45-degree angle toward the inside edge of the groove and then roll downward to press the screen into the groove.
Hold the screen taut across the frame as you roll it into place. Sags and wrinkles are about as attractive on screen doors as they are on people.

Press the spline into the groove using the concave end of the roller.
Tip: Don’t cut the spline at the corners: Instead, bend the spline around the corners and install it in one continuous piece. When you position it tightly in the groove, the spline holds the screen in place.

1
Trim away excess screen.
Place the tip of the knife between the spline and the outside edge of the spline groove and pull the knife slowly along the entire groove perimeter.