
Nehmen Sie den Rahmen ab und legen Sie ihn flach auf eine Arbeitsfläche.
Entfernen Sie das Sieb in seinem Rahmen von der Tür und legen Sie es flach auf eine Werkbank oder einen Satz Sägeböcke.

Hebeln Sie den Keil aus der Nut auf der Rückseite des Rahmens.
Verwenden Sie eine kleine Zange oder eine Zimmermannsahle, um den Keil aus der Nut zu hebeln. Wenn die Ecken eng sind, verwenden Sie einen Schraubendreher, um die Verzahnung zu entfernen. Wenn der Spline in gutem Zustand zu sein scheint, legen Sie ihn für die Verwendung mit dem neuen Bildschirm beiseite.
Wenn der Spline brüchig oder rissig ist, müssen Sie ihn durch einen neuen Spline ersetzen (erhältlich im Baumarkt).

Heben Sie den beschädigten Bildschirm heraus.
Holey screens let in insects — and bats, if the hole is big enough.
Lift out the damaged screen.
Holey screens let in insects — and bats, if the hole is big enough.

Clean the spline groove.
Be sure that you remove even the tiniest grit. You can use the tip of a screwdriver or awl to get into the groove if necessary.

Lay the new fiberglass screen over the frame.
Be sure that it overlaps the groove by at least 1/2 inch on all four sides.

Cut the screen at a 45-degree angle at the corners.
Cut off the corners of the screen at a 45-degree angle, just inside the outer edge of the spline groove.
Cut the screen at a 45-degree angle at the corners.
Cut off the corners of the screen at a 45-degree angle, just inside the outer edge of the spline groove.

Press the screen and the spline into the groove using the concave end of the splining roller.
Hold the roller at a 45-degree angle toward the inside edge of the groove and then roll downward to press the screen into the groove. Roll the first two sides in place and then insert the top and bottom sides.
Hold the screen taut across the frame as you roll it into place. Sags and wrinkles are about as attractive on screen doors as they are on people.

Trim away any excess screen.
Place the tip of the knife between the spline and the outside edge of the spline groove and pull the knife slowly along the entire groove perimeter.