
재료 수집: 면도날 또는 다용도 칼, 뻣뻣한 퍼티 칼, 망치, 드라이버.
칼을 들고 달리기 금지! 날카로운(또는 뾰족한) 물체를 다룰 때는 주의하십시오.

코킹에 점수를 매기고 각 창 스톱 주변에 페인트를 칠하십시오.
면도날이나 다용도 칼로 창 고정대(창틀 내부를 따라 다듬어진 부분)와 프레임 자체 사이를 자릅니다.

창 양쪽에서 멈춤 장치를 제거하십시오.
바닥에서 시작하여 위로 올라가서 퍼티 나이프를 두드려 못이 있는 곳이면 어디든지 멈춤쇠를 느슨하게 풉니다. 새시에서 느슨해진 못을 제거하십시오.
Be careful when removing the window stops and trim. Trim pieces can break easily if you use too much force.
Remove the stops from both sides of the window.
Start at the bottom and work your way up, tap the putty knife to pry the stop loose wherever there’s a nail. Remove the nails after they’re loosened from the sash.
Be careful when removing the window stops and trim. Trim pieces can break easily if you use too much force.

Remove the metal track from the lower side of each window, if necessary.
Some windows have a metal track on each side for the window to slide along. Use the putty knife to gently pry the track free.

Push the lower sash up and lift it out of the window frame.
Push the lower sash up high enough to clear the windowsill and lift it out of the window frame by pulling the bottom toward you.

Detach the cord from its slot on each side of the lower sash.
The cords are attached near the top of each side of the lower sash.
Detach the cord from its slot on each side of the lower sash.
The cords are attached near the top of each side of the lower sash.

Remove the parting strip from each side of the window.
Use the putty knife to gently pry the parting strip loose from each side of the window frame.

Remove the access plate from each side of the lower jamb.
Unscrew the access plate (sash-weight pocket cover) and set it aside. If the jambs don’t have access plates, remove the window casing to get at the cords, weights, and pulleys.

1
Take out the weights from each side of the jamb.
Pull the weights out of the access pocket.
1
Take out the weights from each side of the jamb.
Pull the weights out of the access pocket.

1
Remove the upper sash.
You’ll see the weight pulleys on each side of the upper jamb.

1
Clean out any debris from inside the access panel.
Now you’re ready to take care of your cords. When you are finished, follow the reverse process to put the window back together.