
프레임을 제거하고 작업 표면에 평평하게 놓습니다.
문에서 프레임의 스크린을 제거하고 작업대 또는 톱날 세트에 평평하게 놓으십시오.

프레임 뒷면의 홈에서 스플라인을 들어 올립니다.
작은 펜치나 목수의 송곳을 사용하여 스플라인을 홈에서 빼냅니다. 모서리가 빡빡한 경우 드라이버를 사용하여 스플라인을 제거하십시오. 스플라인의 모양이 양호하면 새 화면에서 사용할 수 있도록 따로 보관합니다.
스플라인이 부서지거나 금이 간 경우 새 스플라인으로 교체해야 합니다(철물점에서 구입 가능).

손상된 화면을 들어 올립니다.
Holey screens let in insects — and bats, if the hole is big enough.
Lift out the damaged screen.
Holey screens let in insects — and bats, if the hole is big enough.

Clean the spline groove.
Be sure that you remove even the tiniest grit. You can use the tip of a screwdriver or awl to get into the groove if necessary.

Lay the new fiberglass screen over the frame.
Be sure that it overlaps the groove by at least 1/2 inch on all four sides.

Cut the screen at a 45-degree angle at the corners.
Cut off the corners of the screen at a 45-degree angle, just inside the outer edge of the spline groove.
Cut the screen at a 45-degree angle at the corners.
Cut off the corners of the screen at a 45-degree angle, just inside the outer edge of the spline groove.

Press the screen and the spline into the groove using the concave end of the splining roller.
Hold the roller at a 45-degree angle toward the inside edge of the groove and then roll downward to press the screen into the groove. Roll the first two sides in place and then insert the top and bottom sides.
Hold the screen taut across the frame as you roll it into place. Sags and wrinkles are about as attractive on screen doors as they are on people.

Trim away any excess screen.
Place the tip of the knife between the spline and the outside edge of the spline groove and pull the knife slowly along the entire groove perimeter.