
Sammeln Sie Ihre Materialien: Fliesenschneider, Ersatzfliese, Fugenmörtel, Bügeleisen, Fliesenkleber, Spachtel, Waschbenzin, Lappen, Schwamm, Nudelholz.
Sie benötigen nur eine kleine Dose Fliesenkleber.

Schneiden Sie zwischen der Fliese und dem Fugenmörtel mit dem Fliesenschneider.
Holen Sie sich einen speziellen Fliesenschneider von einem Baumarkt oder einem Werkzeugverleih.

Erwärmen Sie die Fliese mit einem heißen Bügeleisen.
Das Erhitzen der Fliese mit einem warmen Bügeleisen löst jeglichen Kleber, der die Fliese noch halten könnte.
Erwärmen Sie die Fliese mit einem heißen Bügeleisen.
Das Erhitzen der Fliese mit einem warmen Bügeleisen löst jeglichen Kleber, der die Fliese noch halten könnte.

Heben Sie die lose Fliese mit einem Spachtel heraus.
Heben Sie die lose Fliese vorsichtig mit einem Spachtel an und arbeiten Sie von der Mitte zu den Kanten an allen vier Seiten. Legen Sie die Kachel beiseite.

Lösen Sie den Kleber auf dem Boden auf.
A rag dampened with mineral spirits works great to dissolve the adhesive.

Scrape away the old adhesive.
Use your putty knife to scrape away the dissolved adhesive goo.
Make sure your scraper doesn’t slip and damage surrounding tiles. If you encounter a stubborn spot, use the iron again to warm the adhesive, then scrape it out.
Scrape away the old adhesive.
Use your putty knife to scrape away the dissolved adhesive goo.
Make sure your scraper doesn’t slip and damage surrounding tiles. If you encounter a stubborn spot, use the iron again to warm the adhesive, then scrape it out.

Apply adhesive to the new tile and to the floor.
Coat the empty patch of floor with adhesive.

Put the new tile in place.
You should have enough give to be sure get the tile positioned just right.

1
Roll the tile with the rolling pin.
Pressing hard with the rolling pin will get rid of any trapped air pockets that will cause the tile to lift up.
1
Roll the tile with the rolling pin.
Pressing hard with the rolling pin will get rid of any trapped air pockets that will cause the tile to lift up.

1
Clean up excess adhesive.
A rag dampened with mineral spirits will clean up any adhesive around the edges of the tile.

1
Grout the new tile.
Apply the grout thickly and be sure to get it securely into the gaps.

1
Clean up excess grout.
Use a damp sponge to wipe away the extra grout. If any grout has to be replaced, mix it to match the color of the rest of the grout.
1
Clean up excess grout.
Use a damp sponge to wipe away the extra grout. If any grout has to be replaced, mix it to match the color of the rest of the grout.

1
Weigh down the tile with books.
Keep the books on for a day or two until you’re certain the bond can’t be broken.