
قم بإزالة الإطار وضعه بشكل مسطح على سطح عمل.
قم بإزالة الحاجز الموجود في إطاره من الباب وضعه بشكل مسطح على طاولة عمل أو مجموعة من المنشار.

أخرج الشريحة من الأخدود الموجود في الجزء الخلفي من الإطار.
استخدم كماشة صغيرة أو مخرز نجار لإخراج الشريحة من الأخدود. إذا كانت الزوايا ضيقة ، فاستخدم مفك براغي لإزالة الشريحة. إذا بدا أن الشريحة في حالة جيدة ، فضعها جانبًا لاستخدامها مع الشاشة الجديدة.
إذا كانت الشريحة هشة أو متصدعة ، فيجب استبدالها بشريحة جديدة (متوفرة في متاجر الأجهزة).

ارفع الشاشة التالفة.
Holey screens let in insects — and bats, if the hole is big enough.
Lift out the damaged screen.
Holey screens let in insects — and bats, if the hole is big enough.

Wipe the spline groove clean.
Be sure that you remove even the tiniest grit. You can use the tip of a screwdriver or awl to get into the groove if necessary.

Lay the new aluminum screen over the frame.
Be sure that it overlaps the groove by at least 1/8 inch on all four sides.

Cut the screen at a 45-degree angle at the corners.
Cut off the corners of the screen at a 45-degree angle, just inside the outer edge of the spline groove.
Cut the screen at a 45-degree angle at the corners.
Cut off the corners of the screen at a 45-degree angle, just inside the outer edge of the spline groove.

Press the screen into the groove using the convex end of the splining roller.
Hold the roller at a 45-degree angle toward the inside edge of the groove and then roll downward to press the screen into the groove.
Hold the screen taut across the frame as you roll it into place. Sags and wrinkles are about as attractive on screen doors as they are on people.

Press the spline into the groove using the concave end of the roller.
Tip: Don’t cut the spline at the corners: Instead, bend the spline around the corners and install it in one continuous piece. When you position it tightly in the groove, the spline holds the screen in place.

1
Trim away excess screen.
Place the tip of the knife between the spline and the outside edge of the spline groove and pull the knife slowly along the entire groove perimeter.