
Retire el marco y colóquelo plano sobre una superficie de trabajo.
Retire la pantalla en su marco de la puerta y colóquela sobre un banco de trabajo o un juego de caballetes.

Saque la ranura de la ranura en la parte posterior del marco.
Utilice unos alicates pequeños o un punzón de carpintero para sacar la ranura de la ranura. Si las esquinas están apretadas, use un destornillador para quitar la ranura. Si la spline parece estar en buena forma, déjela a un lado para usarla con la nueva pantalla.
Si la ranura está quebradiza o agrietada, debe reemplazarla con una nueva ranura (disponible en ferreterías).

Levante la pantalla dañada.
Holey screens let in insects — and bats, if the hole is big enough.
Lift out the damaged screen.
Holey screens let in insects — and bats, if the hole is big enough.

Wipe the spline groove clean.
Be sure that you remove even the tiniest grit. You can use the tip of a screwdriver or awl to get into the groove if necessary.

Lay the new aluminum screen over the frame.
Be sure that it overlaps the groove by at least 1/8 inch on all four sides.

Cut the screen at a 45-degree angle at the corners.
Cut off the corners of the screen at a 45-degree angle, just inside the outer edge of the spline groove.
Cut the screen at a 45-degree angle at the corners.
Cut off the corners of the screen at a 45-degree angle, just inside the outer edge of the spline groove.

Press the screen into the groove using the convex end of the splining roller.
Hold the roller at a 45-degree angle toward the inside edge of the groove and then roll downward to press the screen into the groove.
Hold the screen taut across the frame as you roll it into place. Sags and wrinkles are about as attractive on screen doors as they are on people.

Press the spline into the groove using the concave end of the roller.
Tip: Don’t cut the spline at the corners: Instead, bend the spline around the corners and install it in one continuous piece. When you position it tightly in the groove, the spline holds the screen in place.

1
Trim away excess screen.
Place the tip of the knife between the spline and the outside edge of the spline groove and pull the knife slowly along the entire groove perimeter.