
Reúna sus materiales: cortador de baldosas, baldosas de repuesto, lechada, una plancha, adhesivo para baldosas, espátula, alcoholes minerales, trapos, esponja, rodillo.
Solo necesitará una pequeña tina de adhesivo para baldosas.

Corte entre la baldosa y la lechada con el cortador de baldosas.
Obtenga un cortador de azulejos especial en una tienda de mejoras para el hogar o de alquiler de herramientas.

Caliente el azulejo con una plancha caliente.
Calentar la baldosa con una plancha tibia aflojará cualquier adhesivo que aún pueda estar sujetando la baldosa.
Caliente el azulejo con una plancha caliente.
Calentar la baldosa con una plancha tibia aflojará cualquier adhesivo que aún pueda estar sujetando la baldosa.

Levante la baldosa suelta con una espátula.
Levante con cuidado la baldosa suelta con una espátula, trabajando desde el centro hacia los bordes en los cuatro lados. Deja la baldosa a un lado.

Disuelva el adhesivo en el suelo.
A rag dampened with mineral spirits works great to dissolve the adhesive.

Scrape away the old adhesive.
Use your putty knife to scrape away the dissolved adhesive goo.
Make sure your scraper doesn’t slip and damage surrounding tiles. If you encounter a stubborn spot, use the iron again to warm the adhesive, then scrape it out.
Scrape away the old adhesive.
Use your putty knife to scrape away the dissolved adhesive goo.
Make sure your scraper doesn’t slip and damage surrounding tiles. If you encounter a stubborn spot, use the iron again to warm the adhesive, then scrape it out.

Apply adhesive to the new tile and to the floor.
Coat the empty patch of floor with adhesive.

Put the new tile in place.
You should have enough give to be sure get the tile positioned just right.

1
Roll the tile with the rolling pin.
Pressing hard with the rolling pin will get rid of any trapped air pockets that will cause the tile to lift up.
1
Roll the tile with the rolling pin.
Pressing hard with the rolling pin will get rid of any trapped air pockets that will cause the tile to lift up.

1
Clean up excess adhesive.
A rag dampened with mineral spirits will clean up any adhesive around the edges of the tile.

1
Grout the new tile.
Apply the grout thickly and be sure to get it securely into the gaps.

1
Clean up excess grout.
Use a damp sponge to wipe away the extra grout. If any grout has to be replaced, mix it to match the color of the rest of the grout.
1
Clean up excess grout.
Use a damp sponge to wipe away the extra grout. If any grout has to be replaced, mix it to match the color of the rest of the grout.

1
Weigh down the tile with books.
Keep the books on for a day or two until you’re certain the bond can’t be broken.