
Envuelva un poco de cinta adhesiva alrededor de las mordazas de los alicates de unión ranurada o alrededor del aireador para evitar rayones.
Proteja la superficie del aireador.

Agarre el exterior del aireador con los alicates y gire el aireador en el sentido de las agujas del reloj para aflojarlo.
Sé gentil; demasiada presión puede aplastar la carcasa del aireador.

Desmontar el aireador.
Empuje las partes internas fuera de la carcasa del aireador. Un pequeño clip de papel podría ayudar. Si los componentes están atascados, sumerja el aireador en vinagre blanco o una solución de disolución de cal (una parte de vinagre por una parte de agua) durante 30 minutos.
Tip: Cover the sink drain to prevent small parts from accidentally falling down the drain.
Disassemble the aerator.
Push the internal parts out of the aerator housing. A small paper clip might help. If the components are stuck, soak the aerator in white vinegar or lime-dissolver solution (one part vinegar to one part water) for 30 minutes.
Tip: Cover the sink drain to prevent small parts from accidentally falling down the drain.

Use an old toothbrush and a gentle touch to clean the parts.
Don’t bend the screens or you’ll have to replace them.

Reassemble the aerator parts.
Insert the screen, disk, and washer or O-ring (depending on your aerator’s design) in reverse order of disassembly.

Reinstall the aerator on the faucet.
Screw it in by hand in a counterclockwise direction. Use the pliers to tighten securely but there’s no need to over tighten it. Snug is good!