
Rimuovere il telaio e adagiarlo su un piano di lavoro.
Rimuovi lo schermo nella sua cornice dalla porta e appoggialo su un banco da lavoro o su un set di cavalletti.

Fai leva sulla scanalatura fuori dalla scanalatura sul retro del telaio.
Usa delle piccole pinze o un punteruolo da carpentiere per estrarre la scanalatura dalla scanalatura. Se gli angoli sono stretti, utilizzare un cacciavite per rimuovere la scanalatura. Se la spline sembra essere in buone condizioni, mettila da parte per l'uso con il nuovo schermo.
Se la spline è fragile o incrinata, è necessario sostituirla con una nuova spline (disponibile nei negozi di ferramenta).

Estrarre lo schermo danneggiato.
Holey screens let in insects — and bats, if the hole is big enough.
Lift out the damaged screen.
Holey screens let in insects — and bats, if the hole is big enough.

Clean the spline groove.
Be sure that you remove even the tiniest grit. You can use the tip of a screwdriver or awl to get into the groove if necessary.

Lay the new fiberglass screen over the frame.
Be sure that it overlaps the groove by at least 1/2 inch on all four sides.

Cut the screen at a 45-degree angle at the corners.
Cut off the corners of the screen at a 45-degree angle, just inside the outer edge of the spline groove.
Cut the screen at a 45-degree angle at the corners.
Cut off the corners of the screen at a 45-degree angle, just inside the outer edge of the spline groove.

Press the screen and the spline into the groove using the concave end of the splining roller.
Hold the roller at a 45-degree angle toward the inside edge of the groove and then roll downward to press the screen into the groove. Roll the first two sides in place and then insert the top and bottom sides.
Hold the screen taut across the frame as you roll it into place. Sags and wrinkles are about as attractive on screen doors as they are on people.

Trim away any excess screen.
Place the tip of the knife between the spline and the outside edge of the spline groove and pull the knife slowly along the entire groove perimeter.