
Raccogli i tuoi materiali: tagliapiastrelle, piastrella sostitutiva, stucco, ferro da stiro, colla per piastrelle, spatola, acqua ragia minerale, stracci, spugna, mattarello.
Avrai bisogno solo di una piccola vasca di adesivo per piastrelle.

Tagliare tra la piastrella e la fuga utilizzando il tagliapiastrelle.
Procurati un tagliapiastrelle speciale da un negozio di bricolage o di noleggio di attrezzi.

Scaldare la piastrella con un ferro caldo.
Riscaldare la piastrella con un ferro caldo allenta l'eventuale adesivo che potrebbe ancora trattenere la piastrella.
Scaldare la piastrella con un ferro caldo.
Riscaldare la piastrella con un ferro caldo allenta l'eventuale adesivo che potrebbe ancora trattenere la piastrella.

Sollevare la piastrella allentata con una spatola.
Sollevare con cautela la piastrella sciolta con una spatola, lavorando dal centro ai bordi su tutti e quattro i lati. Metti da parte la piastrella.

Sciogliere l'adesivo sul pavimento.
A rag dampened with mineral spirits works great to dissolve the adhesive.

Scrape away the old adhesive.
Use your putty knife to scrape away the dissolved adhesive goo.
Make sure your scraper doesn’t slip and damage surrounding tiles. If you encounter a stubborn spot, use the iron again to warm the adhesive, then scrape it out.
Scrape away the old adhesive.
Use your putty knife to scrape away the dissolved adhesive goo.
Make sure your scraper doesn’t slip and damage surrounding tiles. If you encounter a stubborn spot, use the iron again to warm the adhesive, then scrape it out.

Apply adhesive to the new tile and to the floor.
Coat the empty patch of floor with adhesive.

Put the new tile in place.
You should have enough give to be sure get the tile positioned just right.

1
Roll the tile with the rolling pin.
Pressing hard with the rolling pin will get rid of any trapped air pockets that will cause the tile to lift up.
1
Roll the tile with the rolling pin.
Pressing hard with the rolling pin will get rid of any trapped air pockets that will cause the tile to lift up.

1
Clean up excess adhesive.
A rag dampened with mineral spirits will clean up any adhesive around the edges of the tile.

1
Grout the new tile.
Apply the grout thickly and be sure to get it securely into the gaps.

1
Clean up excess grout.
Use a damp sponge to wipe away the extra grout. If any grout has to be replaced, mix it to match the color of the rest of the grout.
1
Clean up excess grout.
Use a damp sponge to wipe away the extra grout. If any grout has to be replaced, mix it to match the color of the rest of the grout.

1
Weigh down the tile with books.
Keep the books on for a day or two until you’re certain the bond can’t be broken.