
Avvolgere del nastro adesivo attorno alle ganasce delle pinze per giunti scanalati o attorno all'aeratore per evitare graffi.
Proteggere la superficie dell'aeratore.

Afferrare l'esterno dell'aeratore con le pinze e ruotare l'aeratore in senso orario per allentarlo.
Sii gentile; troppa pressione può schiacciare l'alloggiamento dell'aeratore.

Smontare l'aeratore.
Spingere le parti interne fuori dall'alloggiamento dell'aeratore. Una piccola graffetta potrebbe aiutare. Se i componenti sono bloccati, immergere l'aeratore in aceto bianco o soluzione di solvente per calce (una parte di aceto in una parte di acqua) per 30 minuti.
Tip: Cover the sink drain to prevent small parts from accidentally falling down the drain.
Disassemble the aerator.
Push the internal parts out of the aerator housing. A small paper clip might help. If the components are stuck, soak the aerator in white vinegar or lime-dissolver solution (one part vinegar to one part water) for 30 minutes.
Tip: Cover the sink drain to prevent small parts from accidentally falling down the drain.

Use an old toothbrush and a gentle touch to clean the parts.
Don’t bend the screens or you’ll have to replace them.

Reassemble the aerator parts.
Insert the screen, disk, and washer or O-ring (depending on your aerator’s design) in reverse order of disassembly.

Reinstall the aerator on the faucet.
Screw it in by hand in a counterclockwise direction. Use the pliers to tighten securely but there’s no need to over tighten it. Snug is good!